Mopar Sensor Bezel (Dodge, RAM, Jeep - Set of 4)

I installed a rear dV8 bumper on Jeep Wrangler. Then needed to order the bezel for the sensors. I will agree with most of the other reviews. The bezel is made extremely cheap it’s difficult to get them to sit correctly. I needed to remove one to reposition it the hold down ring broke. Just cheap plastic junk but needed for bumper with sensors. I would hope they could come up with a better fit for the sensor bumpers. I wish I would have just modified the rubber plug to hold the sensor in place disappointed in DV8 for not having a better option.

The retainer clip is a little flimsy but a little silicone fixed that. I did not in stall sensors but 3/4 penny lights

I purchased a DV8 rear bumper for 2016 RAM 3500. These bezels are absolutely lousy. They are not deep enough to allow the sensor to snap into the back of the bezel. They also fit very lose thru the bumper.
I ended up throwing them away and fabricated the OEMs to fit perfectly. Had to file the outside diameter of the OEMs down and trim off the tabs. Took about an hour.

I bought the DV8 bezels because I am using DV8 bumpers that the OEM sensors and bezels are too small for. I was under the impression that the bezels would fit the bumper snuggly but that was not the case for the rear bumper. For the front bumper the bezels fit properly and gave me no problems, but for the rear bumper they were too small, so I had to make 2"X2" plastic shims that I epoxied to the back of the bumper so that the bezels would lock securely into place. That was very disappointing.

Very satisfied with product and quick shipping .